COTS-NTDS-IIU_DS1

Digital to Synchro Converter board1(DS1) is a module that converts digital data of Heading or Speed signal of simulator to analog Synchro signal, and transmits the signal to the compass repeater(CR) distribution box and electronic warfare(EW) equipment. It has been designed to meet the IIU requirements of the intagrated combat system for Submarine.

견적문의

Specifications

FunctionsDescriptionsRemarks
MCUST STM32F437VGT6
- ARM 32-bit Cortex-M4F
- 180MHz, 225DMIPS
- 2M single-cycle Flash
- 256+4KB single-cycle SRAM
- 4KB of EEPROM
-
Synchro Output (@ Simulation mode)  INS_90Vl_l/400Hz 3P 1CH(1X)REF : 115V/400Hz 
DSCDigital to Synchro Converter
- 14 Bit
DSC-14-H-3-R
GPIO1 x Input
1 x Output : LED
S/W RESET 
STATUS
RS-2322 x RS-232 interface
- Firmware Update
74HCT1G08GV
CAN2 x CANBUS interface
- Monitoring and Control
SN65HVD233
I2CFor interface with ADC
- For Temp. monitoring
-
USB 2.0

1 x USB 2.0 (EHCI) interface
-For Debug

 

CP2102-GM
I/O Connectors09031646951 x 1
UX60SC-MB-5S8 x 1
for CANBUS, GPIO
for RS-232, I2C 
for AC 3P
for AC 1P, DC_IN 
for USB
Power Supply115V/400Hz, ±12V, +5V, +3.3V  -
Power ConsumptionMax. 4 Watts90VI-I/50mA Max.  
Operating Temperature-40 ~ 85°C-
WeightMax. 1.0KgIncluded frame
Key AngleN/A-
Form Factors3U, 2 slots (100 x 167 x 40mm) Customized
Frame, WedgeLokForward type-